Penglai Huande Steel Valve CO., LTD.

Ten Points for Attention in Repairing Two-piece Internal Screw Ball Valve

(1) The disassembly and decomposition operation can be carried out only after the pressure has been removed from the upstream and downstream pipelines of the ball valve.
(2) The non-metal parts shall be immediately removed from the cleaning agent after cleaning, and shall not be soaked for a long time.
(3) Bolts on the flange shall be tightened symmetrically, step by step and uniformly during assembly.
(4) The cleaning agent should be compatible with rubber, plastic, metal and working medium (such as gas) in the ball valve. When the working medium is gas, the metal parts can be cleaned with gasoline (gb484-89). Clean the non-metal parts with clean water or alcohol.
(5) Each individual ball valve part can be cleaned by soaking. The metal parts of the non-metal parts that have not been decomposed can be scrubbed with a clean, fine cloth impregnated with a cleaning agent. When cleaning, remove all oil, dirt, glue, dust and so on that adhere to the wall surface.
(6) When the ball valve is decomposed and reassembled, the sealing cover of the parts must be carefully prevented from being damaged, especially the non-metal parts. Special tools should be used when removing the O-ring.
(7) After cleaning, assembly shall be carried out after the wall cleaning agent is volatilized, but it shall not be used for a long time, otherwise it will rust and be contaminated by dust.
(8) New parts should also be cleaned before assembly.
(9) Use grease to lubricate. The grease should be compatible with the metal, rubber, plastic and working medium of the ball valve. When the working medium is gas, we can use such as 221 grease. Apply a thin layer of grease to the surface of the sealing element mounting groove, a thin layer of grease to the rubber sealing element, a thin layer of grease to the sealing cover of the stem and the friction surface.
(10) Metal fragments, fibers, grease and dust, other impurities and foreign matters shall not be allowed to contaminate, adhere or stay on the surface of parts or enter the inner cavity during assembly.
Ten Points for Attention in Repairing Two-piece Internal Screw Ball Valve
Related News
  • Are Flanges on Water Globe Valves Having the Same Size?

    Are Flanges on Water Globe Valves Having the Same Size?

    May 7, 20191. It has the standard of American standard flange.2. In the system of the fluid pipeline, the water globe valve is the control element whose main function is to isolate equipment and pipeline system,...view
  • The Use and Future Development of Theaded Steel Ball

    The Use and Future Development of Theaded Steel Ball

    October 9, 2019The Use and Future Development of Theaded Steel Ball Threaded steel ball is widely used in building, bridge, road and other civil engineering construction. From highways, railways, bridges, culverts, ...view
  • Introduction and Type of Check Valve Animation

    Introduction and Type of Check Valve Animation

    May 7, 2019The check valve animation is an automatic valve. It flows forward and closes in reverse flow. The valve is opened by the fluid pressure of the system and any flow reversal closes the valve. The exact ...view
  • Characteristics of Small Bore Ball Valves

    Characteristics of Small Bore Ball Valves

    October 9, 2019Characteristics of small bore ball valves Fluid resistance is small, and the full-diameter ball valve has no flow resistance.2. It has simple structure, small volume and light weight.3. Close and reli...view