Penglai Huande Steel Valve CO., LTD.

The Basic Information of 3 Piece Ball Valve

The selections for ball valves are apparently endless. To pick out a ball valve, choices have to be made. Which seat material? What form of give up connections? Full, reduced, or standard port ball? 2-way or multiport? What about packing? Finally, how many pieces? 
In this post, we talked with Ralph Lechner, one of our software engineers on our valve group to inform us greater about when a three piece ball valve have to be used. 

What is a 3 piece ball valve?

Ball valves come in one, two, or three pieces. One piece ball valves are cheaper and normally not repaired. Two piece ball valves consist of two separate pieces, with the connection between them being both threaded or a bolt and flange assembly. 
As you may have guessed, a 3 piece ball valve consists of three pieces, two stop caps and a body. The end caps are welded, threaded, or flanged to join to the pipe on both side.

Why use a 3 piece ball valve?

For procedures that put heavy needs on valves, having a 3 piece valve is more handy than one or two piece ball valves. When seats and seals need to be mechanically replaced, having three portions allows for convenient disassembly, servicing and reassembly besides having to do primary cutting on the pipe. 
Three piece ball valves also allow for elastomers to be modified to accomodate special manner conditions, temperatures, pressures and flows. 
Need to weld the valve in place? Another benefit is being capable to pass the body with trim out of the way whilst welding, making sure the internals remain intact.

What's the large difference between 2 and 3 piece ball valves?

Two piece ball valves had been also designed with protection in mind. The huge distinction between the two is that the physique on the 3 piece valve can be taken out besides demanding the two give up caps. A two-piece ball valve doesn't often enable this to happen, and it is now not possible at all with a one piece ball valve. 
There's also a rate difference. As mentioned earlier, one piece valves are commonly of the throw away variety. Three piece valves tend to at the startcost more, however can keep money in the lengthy run in terms of time spent maintaining, and ability to change seats and seals vs. changing the valve in its entirety. 
Not positive how many portions you must select for your ball valve application? Ask us about it!We gladly grant technical help to groups and municipalities during the United States.
Related News
  • A Brief Introduction of the Threaded End Valve

    A Brief Introduction of the Threaded End Valve

    May 7, 2019The Characteristics of the ProductsThreaded end valves will not have external leakage and other phenomena. Because the valve seat is composed of carbon fiber reinforced Teflon seal ring and disc sprin...view
  • The Characteristics of 3 Pieces Stainless Ball Valve

    The Characteristics of 3 Pieces Stainless Ball Valve

    May 7, 2019The following characteristics of 3 piece stainless ball valve:1.Fluid resistance is small and its coefficient of resistance is equal to that of the pipe having the same length.2.It has simple structur...view
  • A Brief Introduction of the Ball Valve Male

    A Brief Introduction of the Ball Valve Male

    May 7, 2019The ball valve male and flange gate valve belong to the same type of valve. The difference is that its closing part is a sphere which rotates around the center line of the valve body to open and close...view
  • Application Of Butt Weld Valve

    Application Of Butt Weld Valve

    October 9, 2019There are three main connection modes of valves, flange connection, thread connection and butt weld valve. Application of butt weld valve In the case of larger nominal diameter, higher temperature and...view